Coffee Table build with Spider Legs

Measure and cut your plywood into two 40x40 inch squares.  Cut your squares to a size that best suits your space, I chose this size based on an ottoman/table I already own as my inspo piece.  Be sure to cut these together so the cuts are identical- To do so, just clamp together, then cut(Be sure these mirror each other later when attached). Finally, sand these down for an even, smooth to touch finish. (Pro tip: Make sure your plywood is not bowed for best results.)

Measure and cut your 2x4 into four 8" pieces. Here, I used my first cut as a guide for the other 3- This ensures they are approximately the same length. Then, clamp together and sand to make as even as possible, for optimal results. Having these the same length is crucial for a level surface, no pressure! (Pro tip: Be sure your 2x4 selection is not bowed)

For this, I clamped my 40"x40" square pieces of plywood together.  Using the 2x4 as a guide, I marked my ply with pencil, then cut.  I then sanded these new edges and slightly rounded the corners, no sharp edges!

Here I placed my 2x4 pieces on the ground and placed my base on top.  I moved all four 2x4's to the edge of the ply till it looked perfectly flush.  Once satisfied with placement, I used (2) 2" wood screws per corner, to attach my base.  I used 8 screws total.  

Once I attached my base, I decided to go ahead and attach my spider legs.  But if you prefer, you can attach the top first, then attach legs.  I lined up the bent edge of the leg to the edge of the ply, I really like the look of this way.  If you prefer, you can place the legs further in for better support, your call.  I then attached each spider leg using (12) 3/4" screws.  Time to flip!  

Once you've flipped your table so it's sitting on its legs you can now place your top and fasten.  As stated in Step 1, be sure your top and base mirror each other- same orientation as when they were clamped and cut.  This will ensure the best look possible, no wonkiness ;) (Pro tip: Add some wood putty over the screw faces and sand if you don't want them visible.)

Now you're done!  Stain or paint the top if you'd like and enjoy with coffee or a golden milk latte, it's yours to decide.  Feel free to leave a comment or question below.  Happy to help!